Sansin SDF is specifically engineered to protect log homes, siding, decks, and wooden fences with a one-coat penetrating formula that repels condensed water while allowing water vapor to escape. SDF's specially formulated oils and resins penetrate into the wood, providing outstanding weather and ultra-violet (UV) protection. Thanks to SDF's unique water-borne technology, it can be applied to wood even with high moisture content - SDF lets wood "breathe", preventing moisture from getting trapped inside the logs and causing decay. Sansin SDF will not crack, peel, or blister. Maintenance cycles can be planned every two to three years on horizontal surfaces and three to six years on vertical surfaces depending on the number of coats applied. For best results, apply a flood coat of Sansin SDF, to a point of maximum absorption. Always back-brush the surface a few minutes after application. Continually check the surface; wipe up all puddles and brush out any runs. For additional protection an additional coat of SDF may be applied. The second coat is best applied before the first coat dries so that it can penetrate. If the first coat has dried you can apply a second coat after giving the surface a "scuff" sand. This will allow the second coat to better penetrate. SDF Naturals Topcoat may also be used. SDF may be used as the penetrating primer coat for Sansin ENS. Made in Canada.
Technical Data | SDS
||Apply in proper conditions; ideal temperature of 50-75ºF with relative humidity of approximately 50%.
||330 sq. ft. per gal.
||Brushing, Dipping, Flood coating, or Spraying – hand or automated spraying (low pressure or airless). Always flood surface to the point of saturation.
||Surface must be clean, free from dust, dirt, grease, wax or any existing coatings. Wash entire surface with a minimum 3000 PSI pressure washer with clean water. Sand the surface: See Technical Data for details.
||At 68ºF: Between Coats: 24 hours. To Touch: 4-6 hours. Longer drying time needed in high humidity or low temperature.
||18 months when stored between 50-86°F - Do Not Freeze.
||Soap and Water.
||Flat - Low Luster.
All Colors are Mixed to Order - Nonreturnable
Not Sure on Color? Request a Wet Sample 1-800-359-6614
See Sansin's Virtual Deck to Help Visualize Colors
To order from the full line of SDF Naturals, Translucent, and Saturated colors, choose your color from the Sansin Colors pdf and then add to the cart from the options below - when you check out be sure to include the color name in the comments section.
|PaintCare Notice: Finishes shipped to: CA, CO, CT, DC, ME, MN, NY, OR, RI, VT, & WA will include an additional $0.75 per 1-gal and $1.60 per 5-gal pail sold in order to comply with PaintCare State Law Legislation. (CA is now $0.65 per 1-gal and $1.50 per 5-gal. DC is now $0.70 per 1-gal and $1.60 per 5-gal. MN & VT are now $0.99 per 1-gal and $1.99 per 5-gal pail). To find out more go to www.paintcare.org